Leggett-platt P-2000 Manuel d'utilisateur télécharger pdf (Page 8)

TROUBLE SHOOTING

ELECTRICAL

If the bed does not operate:

• Check the power cord to see that it is securely plugged into the electrical outlet.

• Check the outlet by plugging in a lamp or another electrical device.

• Replace batteries in the remote hand control.

• Perform the Auto Learn Feature outlined on your Remote Operation page.

• If bed still does not work, contact:

Leggett & Platt

Warranty Service Department

P.O. Box 140

Linwood, NC 27299

1-800-888-3078

FOR BEST RESULTS, YOUR BED SHOULD BE PLUGGED INTO A SURGE PROTECTOR.

NOISE CONCERNS

Because of the free fall safety design, the wheels of the lift arm should come into contact with the platform

boards slightly to place tension on the mechanism and reduce a potential noise problem.

The level of noise emitted in most cases is directly proportional to the acoustics of the room where the bed

is placed. Thus, when a bed is on a hardwood floor and the massagers are running, it will transmit the noise

and sound like a base drum. To minimize this noise, place a piece of carpet or a rubber caster cup under

each caster. (Rubber caster cups can be purchased at your local dealer or by calling Customer Service at

1-800-888-3071.)

When the bed is operated, there will be a harmonic hum from the lift motors. This is normal.

LUBRICATION

The lift motors are permanently lubricated. No additional lubrication will ever be required.

Do not apply lubricant to the lift motor lead screw or to the nylon nuts. Any lubrication to these parts may

cause your bed to creep down from the elevated position.

Please have your Model Number, Serial Number and Date Of Purchase available when

calling. If possible, please be in the same location as the bed before calling.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Leggett-platt P-2000 Manuel d'utilisateur Page 8